AxStress Meshing

Joined: 07/03/2018

Post 19 September 2019 09:05:30

AxStress Meshing

Is there anywhere I can find more information on the mesh quality in AxStress?
Last edited by a moderator on 24 June 2020 10:45

Joined: 06/11/2023

Post 09 November 2023 10:18:44

Re: AxStress Meshing

Hello Tala! Thank you for joining our forum!

You can set a mesh quality in the “Mesh parameters” section in the “Preprocessor” branch of the Project Tree. Before calculation, you can specify a mesh quality value in the hub-to-shroud and blade-to-blade directions from 1 to 10 where 1 is the coarsest mesh and 10 is the finest mesh.

Also, you can find some information about the generated mesh in the “Log” tab, such as a number of elements/nodes, degrees of freedom and occurred errors during the calculation.


Kind regards,
Anna Perepelytsia

Quick Reply

 
Powered by MVC Forum v1.5.1 © 2011-2024 creativeminds.
Design by ST Software for blacklist.org.