Joined: 21/01/2021
01 December 2021 20:14:40
exporting the geometry and volute design
greetings all,
i am working on designing a centrifugal fan using Axstream. Can i export the geometry developed in axstream to do cfx analysis on the same?
in my system, the options for exporting are all disabled due to educational license restrictions.
Another doubt, my volute is not being accepted in AxCFD. as it is circular cross section, it is saying unable to cut tongue. but if i change the volute to any other type it immediately accepts it. please give some advice about this as well
i am working on designing a centrifugal fan using Axstream. Can i export the geometry developed in axstream to do cfx analysis on the same?
in my system, the options for exporting are all disabled due to educational license restrictions.
Another doubt, my volute is not being accepted in AxCFD. as it is circular cross section, it is saying unable to cut tongue. but if i change the volute to any other type it immediately accepts it. please give some advice about this as well