**Joined:** 16/02/2017

### Why AxSTREAM Lite dont save in calculation manual deviation angle ?

Good day. I am using AxSTREAM LITE v3.2.1. I am trying to calculate one stage axial turbine in existing analysis.In this calculation i need define manual deviation angle and manual blockage. To do this at "calculation models settings" window for blockage model and deviation angel calc model i set up "fixed loss factor" option. After that, in project tree for stator loses i set up manual value for blockage and manual value actual deviation angle. Further, after calculation i have discover that, AxSTREAM Lite takes into account in calculation only manual value of blockage and did not takes into account manual value of actual deviation angel. After calculation, i save results in project and see that AxSTREAM Lite takes into account only manual blocage value and did not takes into account manual actual deviation angle, because i see default value of actual deviation angle ("0"). To explain more clearer what i mean i make two screenshots from AxMAP module where i do two series of calculations: with variable blockage value and witw variable actual angle value. From this screenshots you can see that blockage value takes into account in calculation (Mass FLow is change) and actual deviation angle is not takes into account in calculation (Mass Flow is const).

May be i doing something wrong or is it limitations for AxSTREAM Lite ?

Link to screenshot:

https://yadi.sk/d/BO2e3lfj3Xqnaz

May be i doing something wrong or is it limitations for AxSTREAM Lite ?

Link to screenshot:

https://yadi.sk/d/BO2e3lfj3Xqnaz

Last edited by a moderator on 30 July 2018 15:25